1) Why is it advisable to eliminate moisture from wood and glass fibre?
2) What is the moisture content foreseen for wood and GRP, according to the Classification Registers?
3) Do wooden and glass fibre boats have advantages if built or repaired with the C-systems' 10 10 cfs or with other epoxy products of the same range?
4) Is case of plywood defects is it possible to use C-systems' 10 10 cfs epoxy resin?
5) Is C-systems' 10 10 cfs rigid or elastic?
6) How does the wooden or GRP hull which was treated with C-systems' 10 10 cfs behave after an accidental impact wich damages the protective layer?)
7) Can the water condition at moorning effect osmosis and rot the wooden hull?
8) Why in glass fibre is osmosis only on the underwater hull?
9) How is to be interpreted when a moisture detector indicates high moisture content in a glass fibre hull without showing bubbles?
10) If it is not possible to take the boat immediately out of the water, in order to repair the protective layer, is water not making the once dehumidified hull wet again?
11) After removingf the gelcoat why is it necessary to wash the hull before the drying and also 1 or 2 days before and during the treatment?
12) But isn't this washing going to wet the hull we worked hard to dry out?
13) If a boat with osmosis reamains out of the water for a long time, will the situation improve or get worse?
14) In summary, what are the steps and work necessary to treat and reapir osmosis?
15) … And the products application sequence?
16) Thanks to C-systems' 10 10 cfs is it possible to reduce wooden and glass fibre boat maintenance and to carry out all repairs?
17) If the wooden boat is not completely dried out is it possible to carry out the treatment with C-system' 10 10 cfs?
18) How is it possible to speed up drying out wooden and glass fibre boats?
19) Sometimessanding "perforates" glass fibre. Isn't it better to go about it in a different way?
20) Are all wooden boats the same?
21) Which are the main differences between solid-wood and plywood?
22) Is it possible to use plywood in place of solid-wood?
23) Does using glass cloth on the hull as well as the new solid wood or plywood (re-planking) for planking mean a reliable job over time?
24) How do you treat planked boats with C-systems' 10 10 cfs?
25) What is the plank seam size that can be perfectly bonded by C-systems' 10 10 cfs ?
26) Can the work described above be started and then continued the weekend after?
27) What the main differences between a conventional cycle and an epoxy cycle with C-systems' 10 10 cfs?
(up)
